Martin Pro Compact Sicherheits- Und Installationshandbuch Seite 8

At a distance of less than 0,2 m (7.9 in.) from the fixture, the light output can
potentially cause eye or skin injury before an exposed person's natural aversion
responses (blink reflex and reaction to skin discomfort) can protect them. At
distances greater than 0,2 m (7.9 in.), potential eye and skin injury hazards from
the light output are normally prevented by natural aversion reflexes.
Position the fixture so that persons cannot be exposed to the fixture's light output
at a distance of less than 0,2 m (7.9 in.) from the fixture and so that prolonged
staring into the light output at less than 1.2 m (4 ft.) is not expected.
Do not look directly into the fixture's light output.
Do not look at the light output with magnifiers, telescopes, binoculars or similar
optical instruments that may concentrate the light output.
Ensure that persons are not looking directly into the front of the fixture when the
product lights up suddenly. This can happen when power is applied, when the
product receives a control signal, or when certain control menu items are selected.
Disconnect the fixture from power at all times when the fixture is not in use.
Provide well-lit conditions to reduce the pupil diameter of anyone working on or
near the fixture.
Protection from injury
Fasten the fixture securely to a fixed surface or structure using a minimum of three
securely anchored bolts, screwbolts or similar fasteners. The fixture is not portable
when installed.
To reduce the risk of strangulation, the flexible wiring connected to this fixture shall
be effectively fixed to the wall if the wiring is within arm's reach.
The weight of the fixture varies depending on configuration, but the fixture weighs
a maximum of 14.1 kg (31.1 lb.) including mounting yoke and with a maximum of
accessories (glare shield, framing module, 4-gobo wheel and animation wheel)
installed.
Ensure that any supporting structure and/or hardware used can hold at least six
(6) times (or more if required by local regulations) the weight of all the devices they
support.
Check that all external covers and installation hardware are securely fastened.
Do not operate the fixture with missing or damaged covers, shields or any optical
component.
Block access below the work area and work from a stable platform whenever
installing, servicing or moving the fixture.
The safety and suitability of lifting equipment, installation location, anchoring
method, mounting hardware and electrical installation are the responsibility of the
installer.
All fasteners used to mount fixtures must be suitable for the application, corrosion
resistant and strong enough to mount the fixture safely.
Block access below the work area and work from a stable platform whenever
installing, setting, adjusting, or cleaning the fixture.
After installation or service, check that the fixture is securely fastened.
In the event of an operating problem, stop using the fixture immediately and
disconnect it from power. Do not attempt to use a fixture that is obviously
damaged.
Do not modify the fixture or install other than genuine Martin parts.
2
The fixture has an Effective Projected Area (EPA) of 0.1 m .
8 Exterior Projection Pro Compact Safety and Installation Manual