Martin Pro Compact Sicherheits- Und Installationshandbuch Seite 78

3. Fasten the male multi-connector (arrowed in photo) on the right-hand side of the fixture (looking
towards the front of the fixture) into the female connector on the top of the animation wheel
module. Note the position of the connector locking clip – the connector can be installed in one
orientation only.
Installing a 4-gobo or single-gobo module
The gobo module has a larger connector than the
animation wheel module.
The procedure for installing an optional gobo wheel
module with 4 gobo slots or one single gobo is the
same. To install a gobo wheel:
1. Check that power to the fixture is shut down.
See photo on right (4-gobo module shown).
The gobo wheel module can only fit into the
effects compartment in one position. Holding
the module as shown, lower it vertically down
into position in the middle slot.
2. Fasten the module into place with its two
captive Allen (hex) screws (circled). Use a
torque driver to tighten the screws to a torque
of 2 Nm.
3. Plug the male connector (arrowed) on the
short wireset on the left-hand side of the fixture
into the female connector on the module. Note
the position of the connector locking clip – the connector can only be installed in one orientation.
Installing a manual framing module
To install a manual framing module:
1. Check that power to the fixture is shut down. Lower the module vertically down into position
closest to the front of the fixture.
2. Fasten the module into place with its two captive Allen (hex) screws. Use a torque driver to tighten
the screws to a torque of 2 Nm.
The manual framing module has no electrical connections.
See photo on right. You can adjust framing with the
effects compartment cover open in dry conditions
and with the fixture powered on and correctly aimed.
Lift the flap (arrowed) and turn the thumbwheels as
follows:
• The two green thumbwheels adjust the angle and
insertion of the bottom blade in the projection.
• The two silver thumbwheels adjust the angle and
insertion of the top blade in the projection.
• The two red thumbwheels adjust the angle and
insertion of the left-hand blade in the projection.
• The two gold thumbwheels adjust the angle and
insertion of the right-hand blade in the projection.
78 Exterior Projection Pro Compact Safety and Installation Manual
Installing a gobo wheel module