Scheppach SG7100x Originalbetriebsanleitung Seite 27

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Failure to comply with the operating instructions
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed
Note:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1 - 10)
1. Fuel filler cap
2. Sight glass
3. Circuit breaker 230 V / 400 V
4. Voltage indicator
5. On-/off switch (e-start)
6. Choke lever
7. Fuel valve
8. Filter cover
8a. Filter
9. Pull starter
10. Transport handle
10a. Split pin
11. Support feet
11a. Hexagonal nut
12. 12V connection
12a. "RESET" button
13. Oil drain screw
14. Oil dipstick
15. 230 V socket (2x)
16. Lead-acid battery
17. Earthing screw
18. 400V socket
19. Transport wheels
19a. Wheel axle
19b. Washer
19c. Spring split pin
20. Spark plug connector
21. Engine
22. Fuel tank
23. Frame
3. Scope of delivery
• Transport handle (10)
• Split pin (10a)
• Support foot (2x) (11)
• Hexagonal nut M8 (11a)
• Transport wheels (2x) (19)
• Wheel axle Ø 13 x 88.5 mm (19a)
• Washer (2x) (19b)
• Spring split pin (2x) (19c)
www.scheppach.com GB | 27