Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Wipe the outside of the device with a
damp cloth.
4. Dry all parts with a cloth.
Steam nozzle
You should disassemble the steam nozzle 8
once a day and clean it thoroughly.
1. Let the steam nozzle 8 cool down.
2. Pull the spout off the steam nozzle 8.
3. Clean the spout thoroughly by hand
with a mild detergent. Rinse several
times with clear, hot water.
4. Wipe the inner tube of the steam noz-
zle 8 thoroughly with a damp cloth.
NOTE: if necessary, use a little detergent.
Clean thoroughly several times with a cloth
that has only been moistened with clear wa-
ter.
5. Slide the spout back onto the steam
nozzle 8.
Filter and portafilter
1. Even if you always use the same fil-
ter 1/2, you should remove it from the
portafilter 19 at least once a week.
2. Rinse the portafilter 19 thoroughly un-
der hot water.
46 GB
3. You can put the filters 1/2 in the dish-
washer.
4. Dry both parts thoroughly before reas-
sembling them.
Water tank
1. You should clean the inside of the water
tank 3 with a little mild detergent ap-
prox. every 2 weeks.
2. Afterwards, rinse it thoroughly with
clear tap water.
3. Wipe the hose 6 thoroughly with a
damp cloth using a little detergent.
Clean thoroughly several times with a
cloth that has only been moistened with
clear water.
4. Dry the water tank 3 from the outside
before inserting it.
16. Descaling
Like any hot water appliance, this espresso
machine must be 0 regularly. Lime deposits
form inside the device and on small open-
ings (e.g. on the steam nozzle 8). This im-
pairs the functionality and damages the
device in the long run.
1. Fill the water tank 3 with cold tap water
up to the MAX marking.
2. Dissolve 2 level tablespoons (approx.
30 grams) of citric acid in it.
3. Push the water tank 3 into the device.
4. Switch on the device with the on/off
switch
22 and let it preheat.
5. The dial 5 is set to OFF.
6. Insert the portafilter 19 without the fil-
ter 1/2.
7. Place a container (approx. 250 ml) un-
der the portafilter 19.
8. When the espresso LED 26 is continu-
ously lit, press the espresso
button
25.
9. Run approx. 250 ml of descaling solu-
tion through it.
10. Press the espresso button
to stop.
25 again
Werbung
