Silvercrest SEM 1050 A2 Bedienungsanleitung Seite 41

10. Press the espresso button
to stop the water.
11. Pour away the dishwater.
12. Turn the handle of the portafilter 19 to
the left until it reaches the symbol
16 and remove it downwards.
13. Rinse the portafilter 19 with the fil-
ter 1/2 with clean water and dry it.
NOTE: when you use the device for the first
time, make approx. 5 cups of espresso and
pour them away. The first cups will not taste
very good.
9.7 Preheating the cups
When the device is ready for use, the hot
plate 4 will be heated up.
• Place the cups on the hot plate 4 to pre-
heat them.
Alternatively, you can use the cup you want
to preheat for flushing. This allows you to
preheat the brewing head 13, filter 1/2
and portafilter 19 and the cup in one step.
Another possibility is preheating with hot
water from the steam nozzle 8 (see "Extract-
ing hot water" on page 42).
9.8
25 again
Rinse the filter 1/2 and the brewing
head 13 with hot water right before each
preparation. This preheating of the filter and
brewing head (flushing) improves the taste of
the espresso.
Requirements:
- The device is ready to be used. The espres-
so LED 26 lights up continuously.
- The dial 5 is set to OFF.
1. Insert the portafilter 19 with the select-
ed filter 1/2 without espresso powder.
2. Place a cup under the portafilter 19.
3. Press the espresso button
approximately the amount of water run
into the container to make one espresso
(approx. 40 ml).
4. Press the espresso button
to stop the water.
5. Leave the hot water in the cup to pre-
heat and pour it out immediately before
the brewing process.
6. Remove the portafilter 19 with
filter 1/2.
7. Dry off the portafilter 19 with
filter 1/2.
Preheating the filter
and brewing head
(flushing)
25 and let
25 again
39
GB