Silvercrest SEM 1050 A2 Bedienungsanleitung Seite 38

9. Preparation
9.1 Filling the water tank
WARNING! Risk of material damage!
Never put liquids other than fresh, cold
drinking water into the water tank 3!
Use fresh water every day.
1. Pull out the water tank 3.
2. Pour out any remaining water from the
water tank 3 and rinse the water tank
several times thoroughly with clean wa-
ter.
3. Fill the water tank 3 with fresh, cold tap
water at least up to the MIN marking
and at most up to the MAX marking.
4. Push the water tank 3 back into the ma-
chine. Note that the hose 6 must pro-
trude into the water tank.
Refill the water in good time
WARNING! Risk of material damage!
To prevent damage to the heating ele-
ment, do not operate the device without
water in the water tank 3.
Always make sure that the water tank 3 is
filled to at least the MIN marking.
36 GB
9.2 Inserting the drip tray
and drip grid
1. Insert the drip tray 12 into the recess
on the device.
2. Place the drip grid 14 on the drip
tray 12 so that the small round hole is
over the float 11.