Scheppach WTS2000 Originalbetriebsanleitung Seite 32

18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not work.
The engine runs slowly
and does not reach the
operating speed.
Engine producing
excessive noise.
The motor does not reach
its full power.
Motor overheats easily.
19. Maintenance plan
Clean guide rails
lubricate guide rails with non-dirt-binding grease
Visual inspection of the product
Exchange water
Cleaning the product
Check mains cable
Change diamond cutting disc
32 | GB
Possible cause
Engine, cable or
connector defective,
mains fuses blown.
Voltage too low, coils
damaged,
Capacitor blown.
Coils damaged, motor
defective.
Power circuits in mains
system overloaded (lamps,
other engines, etc.).
overloading of the motor,
insufficient cooling
of the engine.
www.scheppach.com
Remedy
Arrange for inspection of the product by a specialist.
Never repair the motor yourself. Danger!
Check mains fuses and replace as necessary.
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other products or motors on the same
circuit.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.
Before every use
X
X
X
X
X
Immediately, if defective or worn
after operating for 10
hours
X