In case of breakage, the evaporator of the unit could release refrigerant into the hydraulic circuit. The installer is in charge of designing and protecting the
hydraulic circuit by a safety valve located distant from possible triggering sources.
Clearance and positioning
IMPORTANT!
Before installing the unit, check the noise limits allowed in the place where it will be used.
IMPORTANT!
The unit should be positioned to comply with the minimum recommended clearances, bearing in mind the access to water and electri-
cal connections.
IMPORTANT!
If clearance distances are not maintained at installation, it could cause malfunctioning with an increase in absorbed power and a con-
siderable reduction in cooling capacity.
THAEQI 2100÷2110 – NIAS 15÷13
THAEQI 270÷285 – NIAS 10÷11
THAEQI 2120÷2150 – NIAS 14÷16
Note: The space above the unit must be free from obstacles. The installation must comply with the requirements of the EN 378 standard.