Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Setting up Hettich hinges
Setting up
1. A clockwise 35 mm diameter drill bit is chucked in
the middle drill spindles, and two anticlockwise 10 mm
diameter drill bits are chucked in the rear drilling
spindles. The front drilling spindle must be closed off
with a cap so as to prevent the threaded pin from
working itself out and provide effective protection from
soiling.
Bohrbild
32
L
L
R
L
L
5,5
52
L
Fig. 28: Drilling pattern
2. Set drill depth stop and lock in place with a hexagon nut.
Carry out trial drillings for each to establish the exact
drilling depth.
Fig. 30: Drill depth stop with hexagon head screw
3. Using an Allen key, undo the fence screws and set the
required distance from the edge (C dimension) on the scale.
Fig. 31: Fence with hexagon socket screw
All manuals and user guides at all-guides.com
21
32
Fig. 29: Drilling spindles
with cap
4. Using the scale, set pendulum stops on left and right to the
required dimensions.
Fig. 32: Pendulum stop with hexagon socket screw
WARNING
Do not set any stops near the drilling spindles as other-
wise serious damage could be caused, for example, to
the drilling spindles and drilling unit.
HINWEIS
NOTE
Carry out trial drillings for each to establish the exact
drilling depth.
Drilling
1. Insert workpiece in front of the fence and set the
pendulum stops. Initiate the drilling process using the
manually operated valve or foot switch and terminate
it by releasing.
Fig. 33: Manually operated
valve
2. The Hettich hinge for fast installation on the cup side can
now be fitted by hand.
Fig. 34: Foot switch
67
en
Werbung
