Hettich BlueMax Mini Typ 3 Betriebsanleitung Seite 55

HINWEIS
NOTE
For further Technical Specifications, refer to the
documentation provided by the manufacturers.
Unauthorised changes and modifications to the system are
not permitted for safety reasons and rule out any liability on
the part of the manufacturer for any resultant damage.
2. Controls
Switches and other controls for operating and monitoring the
machine are described below.
1
2
3
Fig. 5: Controls on the automatic drilling and insertion
machine
Item Designation
Motor switch
1
Hand switch
2
Pushbutton
3
1
Fig. 6: Foot switch
Item Designation
Foot switch
1
Pressure regulator
2
Plug in coupler
3
NOTE
The hand switch is not operational when using the foot
switch.
All manuals and user guides at all-guides.com
Explanation
Power supply ON / OFF
For activating work process
For manually releasing the hold-
down clamps
2
3
Fig. 7: Compressed air
connection
Explanation
For activating work process
For setting operating pressure
(6-7 bar)
Compressed air connection
3. Setting up
WARNING
Setup work may only be performed by qualified staff who,
on the basis of their specialised training, experience and
instruction, possess sufficient knowledge of
• safety rules,
• accident prevention regulations,
• guidelines and generally accepted codes of practice.
These qualified staff must be authorised to perform setting
up work by the person responsible for the machine's safety.
4. Safety guards
Separating protective guards complying with EN 953 are
installed on the machine to protect staff from mechanical
hazards.
Warnings / pictograms are also provided on the machine.
Fig. 8: Protective enclosure
en
55