Sharp VC-M23SM Servicehandbuch Seite 26

2. Mounting the shifter (on the back. of the 1. Make.sure that the loading gear is. at.the,point,@ as.shown
below.
2. Place the shifter in position, keeping in mind the 6 insertion
points and the three relief points.
Drum 3. For the phase matching af the insertion point @, see the point
mechanism chassis).
Capstan @ as shown below. peat. acd
b.D. Motor 4. Finally fix the shifter with two washers located on insert points
@ and@.
Reel Pulley | f
se
(Bottom Side of mechanism chassis)
Figure 4-41. Phase-Matching
. Point@_
Loading gear (T}
Insert
Cut Washer Point @
_-;. LX-WZ1041GE00 |
ae ac _
Inset t
Point@
Cut Washer
LX-WZ1073GE00
Release
Point@ Neer
Point @®
Release
Point @
Point @
Phase-Matching.
Point ©
Figure 4-42.
26