Sharp VC-M23SM Servicehandbuch Seite 20

3: 'Align the-left and-of the gear of the A/C headarm tothe mak HEIGHT ADJUSTMENT OF REVERSE GUIDE
on the chassis, and temporarily tighten the screws @. and @
"tocallow the-A/G-head arm to smoothly move. 9 sis.
"' . THeight adjustment of reverse guide]
(Reference: Temporary tightening torque: 0.2 N.m as prefer-
Note: — | ae |
tightened to be loose. ae
@.Remove open lever{Figure 4-29(a)}.
float (5004)
a Figure 4-26.
Height adjusting nut
Figure 4-27.
¢ Adjustment
Adjust the screw (©) visually so that the control headis visible 0.3
to 0.5mm below the bottom of the tape.
Figure 4-29 (b).
20