Mitsubishi Electric MEHP-iB-G07 Installations, Bedienungs Und Wartungsanleitungen Seite 123

9 COMMISSIONING AND ADJUSTMENTS
To change the Setpoint parameters, select the temperature to set between:
• Main Set (cold Set and if applicable hot Set).
• Recovery / DHW Set.
Then click the corresponding box and enter the desired Setpoint value using the relevant pop-up window.
To confirm the value, press the appropriate "Send" icon/button
Installation, use and maintenance manual - Original instructions
The Operating Mode must be changed with the unit switched off. If the unit is on, a pop-up window appears, warning
the user that the change must be performed with the machine powered but switched OFF.
Figure 9.11: unit shutdown warning.
21.04.06
TIME BANDS ACTIVE
17.29.07
INSERT VALUE
8.6
5.0
5.0
Figure 9.12: setpoint value change.
For further information read the W3000+ user and interface manual.
WARNING
or to exit without confirming, press the "Cancel" icon/button or button.
19.4°C
°C
15.0
NOTICE
19.4°C
INSERT VALUE
°C
8.6
5.0 15.0
5.0
SEND
EN
123