If there is an on-board keyboard, to move between the various masks in the menu, make sure that the flashing cursor is positioned in the top left-hand

corner.

•

Press the [UP] and [DOWN] buttons to switch among the various masks in the menu.

•

By pressing the [ENTER] button the cursor moves in the text field. The [UP] and [DOWN] buttons can be used to modify the value of the texts.

•

Press the [ENTER] button multiple times until the cursor returns to the initial position at the top left-hand corner.

9.1.4

Access to the menu

To access the general menu press the MENU [PRG]button on the left.

9.1.5

Setting the operating mode

To change the operating mode access the general menu and select the "setpoint" entry and access to "operating mode".

Make sure the unit is "OFF". Access the "Setpoint menu" and display the "Operating mode" parameter. Move to the "Operating mode" parameter by

pressing [ENTER] and modify the parameter by pressing [UP] or [DOWN]. Press [ENTER] again to confirm. If the set message continues to be displayed

it means that the operating mode has been changed.

Unit type:

Chillers

Operating mode:

Auto

Active adjustment:

Quick Mind in output

9.1.6

Setting the setpoint

Access the "Setpoint menu" and display the "Setpoint set" parameter. Move to the value to modify by pressing [ENTER], and modify the value by pressing

[UP] or [DOWN] as required. Press [ENTER] again to confirm. If the set message continues to be displayed, it means that Setpoint has been changed.

Set setpoint:

Chiller 07.0°C

Heatpump 42.5°C

Recovery/DHW 42.5°C

Overboost 80.0°C

Installation, use and maintenance manual - Original instructions

Figure 9.2: example of the flashing cursor.

Figure 9.3: example of change of values of the texts.

119

Inhaltsverzeichnis