Front Panel; Assembly Procedures; Assembly Flush-Mounted In The Wall - Mitsubishi Electric MEHP-iB-G07 Installations, Bedienungs Und Wartungsanleitungen

9 COMMISSIONING AND ADJUSTMENTS
9.7

Front panel

Mechanical section
9.8

Assembly procedures

The Touch Room HMI 4.3" allows two types of assembly according to user requirements:
• Flush-mounted in the wall.
• Cantilevered from the wall.
9.8.1

Assembly flush-mounted in the wall

The image below shows the housing dimensions in the wall for flush-mounted assembly:
The procedure for correct assembly is as follows:
· Insert the flush-mounting box into the hole previously made in the wall.
· Insert the Touch Room HMI into the flush-mounting box and screw it to the box.
· Attach the plate to the front of the Touch Room HMI.
The installation kit supplied by the manufacturer includes: screws, front plate and flush-mounting box.
The figure below shows the steps for correct assembly:
Installation, use and maintenance manual - Original instructions
Figure 9.21: front panel of the Touch Room HMI.
Figure 9.22: dimensions for flush-mounted assembly.
Dimensions
Width 148.3 mm
Depth 54.2 mm
Height 86.9 mm
Table 17: dimensions for flush-mounted assembly.
Figure 9.23: representation of correct assembly.
EN
129