Herunterladen Inhalt Inhalt Diese Seite drucken

Quick-Teach-Procedure For Devices With Switching Output - turck FM-IM Serie Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Instruction manual FM-IM / FMX-IM
7.1.2

Quick-Teach-Procedure for devices with switching output

(FM(X)-IM-3UP63X, FM(X)-IM-3UR38X)
(menu structure Figure A, see inside front cover)
The Quick-Teach-Procedure is a simple switchpoint setting of the flow rate
with out teaching of the display range (MAX/MIN trim). For this purpose the
device is in display mode (Flow Display).
➤ Set the flow rate to the desired value.
➤ Push the "Enter" button one time.
DeltaFlow-Monitoring (∆ Flow Monitoring) (see Chapter 3.5.2 on p. 14)
starts.
If the entire LED-band is blinking green instead of yellow, the operation
can be continued.
➤ Push the "Enter" button for 5 s (equals 5 × blinking).
LED 5 on the band display changes from green to yellow; the rest of the LEDs
on the band display are synchronously blinking green. After 5 s (equals 5  ×
blinking), the green LEDs on the band display extinguish; LED 5 continues
to blink in the same rhythm. The actual flow rate of the monitored system is
taught as Teach-Value.
➤ Push in increments the "Set" button or push in increments the "Mode"
button (Set SP Flow).
Pushing the "Set" button increases the switchpoint in increments.
Pushing the "Mode" button decreases the switchpoint in increments.
➤ Push the "Enter" button one time.
The switchpoint is stored.
The entire LED-band will be green for 1 s, afterward the switchpoint is
stored and the device switches to the display mode (Flow Display).
32
Hans Turck GmbH & Co. KG • Tel. +49 (0) 208/4952-0 • Fax +49 (0) 208/4952-264

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis