Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2.2
HART®-Communication
The signal processor FMX-IM-2UPLi63X is equipped with the HART® commu-
nication protocol.
The signal processor can be connected to the HART®-Master/-Modem via Ter-
minals 11 and 16 or via the 3.5 mm jack plug COM (PC) on the front side (see
Chapter 6 on p. 21). For connection via the 3.5 mm jack plug COM (PC), the
communication adapter IM-PROG III (Ident-No. 7525111) is needed.
Please refer to the document "HART®-Parameter – FMX-IM-2UPLi63X"
(D101930) for operating the devices via HART®.
This document is online in PDF format.
7.2.3
Software- and documentation-download
You will need the following software components for complete installation on
your computer:
■
FDT-Frame Application PACTware™
■
device-specific software module IODD or DTM:
– IODD for FM(X)-IM with IODD-Interpreter or
– DTM Setup for IO-Link Devices or
– DTM Setup for HART® Devices
BASIC TECHNICAL INFORMATION
PACTware™
PACTware™ signifies „Process Automation Configuration Tool" and is an open
configuration software that any manufacturer may use to integrate his field
devices.
All software components can be downloaded for free.
The following documents can also be downloaded in PDF format for software-
based start-up with a master.
■
IO-Link-Parameter – FM-IM / FMX-IM (D101920)
■
HART®-Parameter – FMX-IM-2UPLi63X (D101930)
■
Getting started – FDT/DTM Frame PACTware™ with IO-Link (D101931)
8
Disposal
The device must be separated from normal waste and disposed of according to
Guideline 2002/96/EG (WEEE).
Please take under consideration whether the device because of its application
in certain processes was in contact with material that would require disposal
according to other regulations and guidelines. In this case, please dispose the
device according to the respective regulations and guidelines.
more@turck.com • www.turck.com • 2012/12
Disposal
37
Werbung
Inhaltsverzeichnis
