turck FM-IM Serie Betriebsanleitung Seite 74

Instruction manual FM-IM / FMX-IM
Switchpoint setting of temperature monitoring (SP Temp)
IMPORTANT INFORMATION
No DeltaFlow-Monitoring with relative values
DeltaFlow-Monitoring has no significance for setting the switchpoint, because
it involves Parametrization of a relative value.
➤ You completed the display range setting ((MAX/MIN trim), or push the
➤
"Mode" button three times in the display mode.
Switchpoint setting of temperature monitoring (SP Temp) starts; the display
is yellow.
➤ Push the "Set" button for 5 s (equals 5 × blinking).
➤
Wait until the display is yellow again.
➤ Push in increments the "Set" button or push in increments the "Mode"
➤
button (Set SP Temp tens (decade)).
Pushing the "Set" button increases the switchpoint by 20 °C at a time.
Pushing the "Mode" button decreases the switchpoint by 20 °C at a time.
➤ Push the "Enter" button one time.
➤
The switchpoint is stored.
➥ ➤ The entire LED-band will be green for 1 s, afterward the switchpoint is
stored and setting of the unit position (Set units) starts. The display is
yellow.
Setting is skipped by pushing the "Mode" button.
➤ Push the "Set" button for 5 s (equals 5 × blinking).
➤
Wait until the display is yellow again.
➤ Push in increments the "Set" button or push in increments the "Mode"
➤
button (Set SP Temp units (unit position)).
Pushing the "Set" button increases the switchpoint by 2 °C at a time.
Pushing the "Mode" button decreases the switchpoint by 2 °C at a time.
➤ Push the "Enter" button one time.
➤
The switchpoint is stored.
The entire LED-band will be green for 1 s, afterward the switchpoint is
➥ ➤
stored and the device switches to the display mode (Flow Display).
30
Hans Turck GmbH & Co. KG • Tel. +49 (0) 208/4952-0 • Fax +49 (0) 208/4952-264