Dismounting, Return And Disposal; Dismounting; Return - WIKA CPH6000 Betriebsanleitung

10. Dismounting, return and disposal

9. Dismounting, return and disposal
Personnel: Skilled personnel
Protective equipment: Protective gloves, safety goggles
Tools: Open-ended spanner or torque wrench
EN
WARNING!
Physical injuries and damage to property and the environment through residual media
Residual media at the instrument can result in a risk to persons, the environment and equipment.
▶
Wear the requisite protective equipment.
▶ Observe the information in the material safety data sheet for the corresponding medium.
▶ Wash or clean the dismounted instrument, in order to protect persons and the environment from exposure to
residual media.
9.1

Dismounting

WARNING!
Physical injury
During dismounting there is a risk of high pressures.
▶
Disconnect test and calibration installations once the system has been depressurised!
9.2

Return

Strictly observe the following when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazardous substances (acids, bases, solutions, etc.) and must
therefore be cleaned before being returned.
WARNING!
Physical injuries and damage to property and the environment through residual media
Residual media at the instrument can result in a risk to persons, the environment and equipment.
▶
With hazardous substances, include the material safety data sheet for the corresponding medium.
▶
Clean the instrument, see chapter 8.2 "Cleaning".
When returning the instrument, use the original packaging or a suitable transport packaging.
Instruments with lithium-ion rechargeable batteries or lithium-metal batteries
The lithium-ion rechargeable batteries or lithium-metal batteries included are subject to the requirements of the dangerous
goods law. Special requirements for packaging and labelling must be observed when shipping. A dangerous goods expert
must be consulted when preparing the package. Do not send any damaged or defective rechargeable batteries. Mask open
contacts and pack the rechargeable battery so that it does not move in the packaging and also prevents short-circuits.
Observe the different dangerous goods requirements relative to the respective modes of transport and any other national
regulations.
▶
Do not ship the instrument if the rechargeable battery is damaged or defective.
▶
The rechargeable battery is permanently installed in the pressure calibrator. In case the rechargeable battery stops
working, contact the manufacturer.
▶
The rechargeable battery is a consumable. All rechargeable batteries have a limited number of charging cycles and may
need to be checked at any given time. If you notice that the pressure calibrator must be charged more frequently, contact
the manufacturer immediately.
For contact details, see chapter 1 "General information" or the back page of the operating instructions.
44 WIKA operating instructions, pressure calibrator model CPH6000