Display: Units And Resolution; Operating Modes; Measuring Mode - WIKA CPH6000 Betriebsanleitung

6. Commissioning, operation

6.7.1 Display: Units and resolution

After selecting one of the main menu items from the SETUP menu, e.g.: MEASURING, CALIBRATION or SWITCH TEST,
using the menu item Unit, and its associated submenu respectively, you can set the unit and resolution.
For available units, incl. their conversion factor in relation to the unit bar, see chapter 10.8 "Available pressure range and
EN
resolution".
1. With [SETUP], select the menu.
2. With [▲] or [▼], select the menu item Unit.
3. With [◀], [▶], [▲] or [▼] select the unit.
4. Confirm with [SELECT]
5. With [▲] or [▼], select the menu item User.
6. Enter unit via numeric keypad.
7. Confirm with [SELECT]
8. With [▲] or [▼], select the Resolution.
9. With [◀] or [▶], select the accuracy of resolution.
10. Confirm with [SELECT]
11. Back with [BACK].
Selection of the standard unit
1
Customer-specific unit; with respect to bar
2
(input via numeric keypad)
Display resolution in operating mode.
3
6.8

Operating modes

6.8.1 MEASURING mode

Accessing MEASURING mode:
1. With [SETUP], access the main menu.
2. With [▲] or [▼], select the menu item MEASURING.
3. Confirm with [SELECT].
⇒
The submenu MEASURING is displayed.
Preparing for MEASURING:
To switch the instrument to MEASURING mode, the following settings must be made
beforehand.
▶
With [▲] or [▼], select menu item.
▶
Use [◀] or [▶] to make the configuration.
▶
When finished, confirm all settings with [SELECT].
⇒
MEASURING mode is initiated.
30 WIKA operating instructions, pressure calibrator model CPH6000
...Unit/Resolution
bar mbar hPa
inHg cmHg
psi
1
MPa kPa Pa
mH2O cmH2O mmH2O
kg/cm2 inH2O mmHg
2
User: 1.00000
3
Resolution: 10.000
Unit of test item
.Configuration
MEASURING
CALIBRATION
SWITCH-TEST
Functions
CPH-Info
ReferenceSensor
Ref. Sensor-list
CPH-Configuration
Interface
CLEAR CalProg
CPH switch off