Transport, Packaging And Storage; Transport; Packaging And Storage - WIKA CPH6000 Betriebsanleitung

5. Transport, packaging and storage

5. Transport, packaging and storage
5.1

Transport

Check the instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
When unloading packed goods upon delivery as well as during internal transport, proceed carefully and
observe the symbols on the packaging.
▶ With internal transport, observe the instructions in chapter 5.2 "Packaging and storage".
If the instrument is transported from a cold into a warm environment, the formation of condensation may result in instrument
malfunction. Before putting it back into operation, wait for the instrument temperature and the room temperature to equalise.
5.2

Packaging and storage

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature
Relative humidity
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
Store the instrument in its original packaging in a location that fulfils the conditions listed above. If the original packaging is not
available, pack and store the instrument as described below:
1. The battery level during storage or shipping should be between 25 and 50 %.
2. Wrap the instrument in an anti-static plastic film.
3. Place the instrument, along with the shock-absorbent material, in the packaging.
4. If stored for a prolonged period of time (more than 30 days), place a bag containing a desiccant inside the packaging.
WIKA operating instructions, pressure calibrator model CPH6000
Pressure sensor
-40 ... +85 °C [-40 ... +185 °F]
0 ... 95 % r. h. (non-condensing)
Hand-held
-20 ... +70 °C [-4 ... +158 °F]
0 ... 85 % r. h. (non-condensing)
Power supply unit
-40 ... +85 °C [-40 ... +185 °F]
5 ... 95 % r. h. (non-condensing)
19
EN