8. Faults / 9. Dismounting, return and disposal
Display
Cause
No display or
Battery flat
undefinable
System error
characters,
instrument is not
responding to
key press
Technical fault
CAUTION!
If faults cannot be eliminated by means of the measures listed above,
the hand-held pressure calibrator must be shut down immediately, and it
must be ensured that pressure and/or signal are no longer present, and it
must be prevented from being inadvertently put back into service.
In this case, contact the manufacturer.
If a return is needed, please follow the instructions given in chapter
9.2 "Return".
9. Dismounting, return and disposal
WARNING!
Residual media on the hand-held pressure calibrator can result in
a risk to persons, the environment and equipment. Take sufficient
precautionary measures.
9.1 Dismounting
Only disconnect the instrument once the system has been depressurised!
9.2 Return
WARNING!
Strictly observe the following when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of
hazardous substances (acids, bases, solutions etc.).
When returning the instrument, use the original packaging or a suitable transport
package.
WIKA operating instructions, model CPH65I0
Measures
Insert new batteries
Switch off the instrument, wait
for a short period of time, switch
on again
Send in for repair
GB
47