Dismounting, Return And Disposal; Dismounting; Return; Disposal - WIKA CTD4000 Betriebsanleitung

11. Dismounting, return and disposal

11. Dismounting, return and disposal
Personnel: Skilled personnel
Protective equipment: Protective gloves
WARNING!
Physical injuries and damage to property
and the environment through residual media
Residual media on or in the instrument can
result in a risk to persons, the environment and
equipment.
▶ Wear the requisite protective equipment.
▶
Observe the information in the material safety
data sheet for the corresponding medium.
▶
Clean the instrument, in order to protect
persons and the environment from damage
through residual media.
11.1

Dismounting

WARNING!
Risk of burns
During dismounting there is a risk of high
temperatures.
▶
Let the instrument cool down sufficiently
before dismounting it!
▶
In order to cool down the metal block, set the
set temperature to a low temperature, e.g.
room temperature.
DANGER!
Danger to life caused by electric current
Upon contact with live parts, there is a direct
danger to life.
▶
The dismounting of the instrument may only
be carried out by skilled personnel.
▶ Disconnect test and calibration installations
once the system has been isolated from
power sources.
1. Cool down the temperature dry-well calibrator as
described in chapter 6.9 "Cooling down the metal block".
2. Switch off the temperature dry-well calibrator and pull out
the mains plug from the mains socket.
After switching off or after removing the mains
connection, the installed fan can no longer
provide cooling air. If the voltage supply is
interrupted during the cooling process, sufficient
thermal decoupling is still guaranteed between
the metal block and the case.
WIKA operating instructions, model CTD4000
11.2

Return

Strictly observe the following when shipping the
instrument:
All instruments delivered to WIKA must be free from any
kind of hazardous substances (acids, bases, solutions, etc.)
and must therefore be cleaned before being returned, see
chapter 10.2 "Cleaning".
When returning the instrument, use the original packaging or
a suitable transport packaging.
To avoid damage:
1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument, along with the shock-absorbent
material, in the packaging. Place shock-absorbent
material evenly on all sides of the transport packaging.
3. If possible, place a bag, containing a desiccant, inside the
packaging.
4. Label the shipment as transport of a highly sensitive
measuring instrument.
Information on returns can be found under the
heading "Service" on our local website.
11.3

Disposal

Incorrect disposal can put the environment at risk.
Dispose of instrument components and packaging materials
in an environmentally compatible way and in accordance with
the country-specific waste disposal regulations.
Do not dispose of with household waste. Ensure
a proper disposal in accordance with national
regulations.
EN
27