Installation; Fixing; Fixture Dh24Bv - Optimum OPTIdrill DH 28BV Betriebsanleitung

3.4

Installation


Check the horizontal orientation of the base of the drilling machine with a spirit level.

Check that the foundation has sufficient floor-load capacity and rigidity. Place the drilling
machine on the provided underground.

Fix the drilling machine in the provided through-holes on the machine foot.
WARNING!
The condition of the underground and the fixing type of the machine foot to the
underground must be in a way that it can bear the loads of the drilling machine. The
underground must be level. Check the horizontal orientation of the base of the drilling
machine with a spirit level.
3.5

Fixing

In order to provide for the necessary stability of the drilling machine connect the drilling
machine with its foot to the substructure. We recommend you to use shear connector cartridges
resp. heavy-duty anchors.

Fix the foot of the geared drill to the substructure with the provided through-holes.
ATTENTION!
Tighten the fixing screws of the drilling machine only as much that it is safely fixed and
cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand.
3.6

Fixture DH24BV

Img.3-1: Marking of the fixing points on the DH24BV
GB
DH24BV | DH28BV | DH34BV | DH40BV
88 Originalbetriebsanleitung
2x
Version 1.1.4 - 2022-09-14