4.4
Fixing
In order to provide for the necessary stability of the geared drill,
it is necessary to firmly bolt the base of the machine to the subsurface.
We recommend you to use shear connector cartridges resp. heavy-duty anchors.
Fix the foot of the geared drill to
the substructure with the provided
through-holes.
The Through-bore are marked
with arrows on the machine base.
ATTENTION!
Tighten the fixing screws of the geared drill only as much that it is safely fixed and
cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand.
GB
B34H | B34HV
92
Through-
Arrow sign
Abb.4-8:
Arrow sign
Through-bore
Abb.4-9:
Abb.4-10: Example ground fastening
Translation of the original instructions
bore
Labeling of the anchorage point B34H
Labeling of the anchorage point B34H
Assembly
Version 1.1.3 - 2020-07-21