1.11.2 Drill Chuck Guard; Personal Protective Equipment - Optimum OPTIdrill DH 35G Betriebsanleitung

1.11.2 Drill chuck guard

Adjust the guard to the correct height before you start working.
To do so, slacken the clamping screw, set the required height and re-tighten the clamping
screw.
There is a switch integrated in the spindle protection mounting which monitors the closed posi-
tion.
INFORMATION
The machine cannot be started, if the drill chuck guard is not closed and the locking pin
of integrated drill drift is in drifting position.
Clamping screw
Locking pin
Integrated
drill drift
Drill chuck guard
1.12

Personal protective equipment

For some works you need personnel protective equipment as protective equipment. These are
Safety helmet,

protective glasses or face guard,

protective gloves,

safety shoes with steel toe caps,

ear protection.

Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness.
Clean your personal protective equipment
after each use,

regularly once a week.

Personal protective equipment for special works
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
EN
DH35G
66
Img.1-4: Drill chuck guard
Translation of original instruction
Safety
Version 1.0.4 - 2022-02-15