Safety - Optimum OPTIdrill DM35 Betriebsanleitung

1

Safety

Glossary of symbols
 provides further instructions

calls on you to act
listings

This part of the operating instructions
explains the meaning and use of the warning notes included in these operating instructions,

defines the intended use of the magnetic drill,

points out the dangers that might arise for you or others if these instructions are not

observed,
informs you about how to avoid dangers.

In addition to these operation instructions, please observe
the applicable laws and regulations,

the statutory provisions for accident prevention,

the prohibition, warning and mandatory signs as well as the warning notes on the magnetic

drill.
Always keep this documentation close to the magnetic drill.
INFORMATION
If you are unable to rectify an issue using these operating instructions, please contact us for
advice:
Optimum Maschinen Germany GmbH
Dr. Robert-Pfleger-Str. 26
D-96103 Hallstadt
email: info@optimum-maschinen.de
Machine variants
The variant for you machine is specified on the rating plate.
OPTIdrill DM35

OPTIdrill DM35V - with stepless speed.

OPTIdrill DM35PF - with spindle sleeve feed.

OPTIdrill DM36VT - with thread-cutting function and stepless speed.

OPTIdrill DM38VF - In flat design. The flat design is suitable for hard to reach drilling sites

with low heights.
OPTIdrill DM50

OPTIdrill DM50V - with stepless speed.

OPTIdrill DM50PM - with permanent magnet.

OPTIdrill DM60V - with stepless speed.

OPTIdrill DM98V - with stepless speed.

Version 1.0.7 dated 2019-09-25
DM35│DM35V│DM35PF│DM36VT│DM38VF│DM50│DM50V│DM50PM│DM60V│DM98V
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
GB
Page 23