Appendix; Copyright; Terminology/Glossary; Change Information Operating Manual - Optimum OPTIdrill B 34H Betriebsanleitung

9

Appendix

9.1

Copyright

This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
9.2

Terminology/Glossary

Term
Drill drift
Drill chuck
Drill head
Drill sleeve
Drilling spindle
Drilling table
Taper mandrel
Spindle sleeve lever
Quick-action drill chuck
Workpiece
Tool
9.3

Change information operating manual

Chapter
4.2, 4.9, 6.2
EC declaration
4.9
CE +
Parts
parts
1 , 2 , parts
3
Appendix
Version 1.1.3 - 2020-07-21
Explanation
Tool to release the bit or the drill chuck from the drill spindle
Drill holding fixture
Upper part of the geared drill
fixed hollow shaft which runs in the drill spindle.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
drill holding fixture to be clamped manually.
part to be drilled, part to be machined.
Milling cutter, drill bit, countersink, etc.
Short note
Chip filter
changed standard
Warning
EMC 2014/30/EU & LVD 2014/35/EU
Controller type V3.23 for B34HV
Permanently lubricated plain bearings, pos. 167, 168
EMC categories , modificated drilling table
Interdepartmental transport
Translation of the original instructions
new version number
1.0.7
1.0.8
1.0.9
1.1.0
1.1.1
1.1.2
1.1.3
B34H | B34HV GB
119