Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
Appendix
8.1
Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
Term
Drill drift
Drill chuck
Drill head
Drill sleeve
Drilling spindle
Drilling table
Taper mandrel
Spindle sleeve lever
Quick-action drill chuck
Workpiece
Tool
EN
DH35G
98
Explanation
Tool to release the bit or the drill chuck from the drill spindle
Drill bit adapter
Upper part of the geared drill
Fixed hollow shaft which runs in the drill spindle.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
Drill holding fixture to be clamped manually.
Part to be drilled, part to be machined.
Drill bit, countersink, etc.
Translation of original instruction
Appendix
Version 1.0.4 - 2022-02-15
Werbung
Inhaltsverzeichnis
