Appendix; Copyright; Terminology/Glossary; Change Information Operating Manual - Optimum Optidrill B 24H Betriebsanleitung

8

Appendix

8.1

Copyright

This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2

Terminology/Glossary

Term
Drill drift
Drill chuck
Drill head
Drill sleeve
Drilling spindle
Drilling table
Taper mandrel
spindle sleeve lever
Quick-action drill chuck
Workpiece
Tool
8.3

Change information operating manual

Chapter Short summary
4.2.2; 4.10; 6.2 Chip filter
EC declaration changed standard
EC declaration additional standards
Spare parts Machine illumination 12V; 24V
Wiring diagram Machine illumination 12V; 24V
parts New table for B28H
parts Permanently lubricated plain bearings, pos. 165 , 245 , 127 , 308
1 , 2 , parts EMC categories , drilling table
3 Interdepartmental transport
GB
B24H | B24HV | B28H | B28HV
136
Explanation
Tool to release the bit or the drill chuck from the drill spindle
Drill bit adapter
Upper part of the drilling machine
Fixed hollow shaft which runs in the drill spindle.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
Drill holding fixture to be clamped manually.
Part to be drilled, part to be machined.
Drill bit, countersink, etc.
Translation of the original instructions
new version number
2.2.0
2.2.1
2.2.2
2.2.2
2.2.2
2.2.3
2.2.4
2.2.5
2.2.6
Appendix
Version 2.2.6 - 2020-07-21