4.2.3
Mounting the drilling table
Push the toothed rod into the
drilling table
Adjust the toothed rod within
the drilling table in a way that
the teeth of the toothed rod
came in with the worm gear of
the drilling table.
Push the drilling table with the
toothed rack on the drilling
column.
Mount the spacer.
Mount the crank handle for the height-adjustment of the drilling table.
Clamp the crank handle and the spacer with the locking screws respectively with the hex-
agon socket screws.
Assembly
Version 1.1.3 - 2020-07-21
Drilling table
Toothed rack
Drill column
Stud screw
Spacer
Threaded pin
Hexagon socket screw
Crank handle
Abb.4-4:
Translation of the original instructions
Abb.4-3:
Assembling drilling table
Assembly crank handle
B34H | B34HV
GB
89