Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
Appendix
8.1
Copyright
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
Term
Drill chuck
Drill head
Drill sleeve
Drilling spindle
Drilling table
Taper mandrel
Spindle sleeve lever
Quick-action drill chuck
Workpiece
Tool
8.3
Change information operating manual
Chapter
4.2.2; 4.8; 6.2
2.1
CE
CE
2 +
2
parts
parts
Appendix
Version 1.1.8 dated 2018-9-13
Explanation
Device for holding the bit
Upper part of the bench drilling machine
fixed hollow shaft which runs in the drill spindle.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
drill holding fixture to be clamped manually.
part to be drilled, part to be machined.
Milling cutter, drill bit, countersink, etc.
Short note
Speed B16HV
Electrical connection
EC declaration
EMC 2014/30/EU & LVD 2014/35/EU
B16H 230V changed to 400V
B16HV drilling capacity
Permanently lubricated plain bearings, pos. 173 , 174
Updating the spare parts list (09 / 2018)
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
new version number
1.1.3
1.1.4
1.1.5
1.1.6
1.1.7
1.1.7
1.1.8
1.1.8
B16H | B16HV
®
GB
Page 93
Werbung
Inhaltsverzeichnis
