Appendix; Copyright; Liability Claims/Warranty; Decommissioning - Optimum OPTIdrill DM35 Betriebsanleitung

7

Appendix

7.1

Copyright

This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
7.2

Liability claims/warranty

Besides the legal liability claims for defects of the customer towards the seller, the manufac-
turer of the product, OPTIMUM GmbH, Robert-Pfleger-Straße 26, D-96103 Hallstadt, does not
grant any further warranties unless they are listed below or were promised as part of a single
contractual provision.
Liability or warranty claims are processed at OPTIMUM GmbH's discretion either

directly or through one of its dealers.
Any defective products or components of such products will either be repaired or
replaced by components which are free from defects. Ownership of replaced products
or components is transferred to OPTIMUM Maschinen Germany GmbH.
The automatically generated original proof of purchase which shows the date of purchase,

the type of machine and the serial number, if applicable, is the precondition in order to
assert liability or warranty claims. If the original proof of purchase is not presented, we are
not able to perform any services.
Defects resulting from the following circumstances are excluded from liability and warranty

claims:
- Using the product beyond the technical options and proper use, in particular due to over-
straining of the machine.
- Any defects arising by one's own fault due to faulty operations or if the operating manual
is disregarded.
- Inattentive or incorrect handling and use of improper equipment
- Unauthorized modifications and repairs
- Insufficient installation and safeguarding of the machine
- Disregarding the installation requirements and conditions of use
- atmospheric discharges, overvoltage and lightning strokes as well as chemical influences
Neither are the following items covered by liability or warranty claims:

- Wearing parts and components which are subject to normal and intended wear, such as
V-belts, ball bearings, lighting, filters, seals, etc.
- Non reproducible software errors
Any services, which OPTIMUM GmbH or one of its agents performs in order to fulfil any

additional warranty are neither an acceptance of the defects nor an acceptance of its obli-
gation to compensate. These services neither delay nor interrupt the warranty period.
The court of jurisdiction for legal disputes between businessmen is Bamberg.

If any of the aforementioned agreements is totally or partially inoperative and/or invalid, a

provision which nearest approaches the intent of the guarantor and remains within the
framework of the limits of liability and warranty which are specified by this contract is
deemed agreed.
7.2.1

Decommissioning

CAUTION!
Used devices need to be decommissioned in a professional way in order to avoid later
misuses and endangerment of the environment or persons.

Unplug the power cord and cut the connection cable.

Disassemble the machine if required into easy-to-handle and reusable assemblies
and component parts.
Version 1.0.7 dated 2019-09-25
DM35│DM35V│DM35PF│DM36VT│DM38VF│DM50│DM50V│DM50PM│DM60V│DM98V
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
GB
Page 35