Safety; Control Panel B34H - Optimum OPTIdrill B 34H Betriebsanleitung

5.2

Safety

Use the machine only under the following conditions:

The machine is in proper working order.

The machine is used as prescribed.

The operating manual is followed.

All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the machine immediately in the event of any
anomaly in operation and make sure it cannot be started up accidentally or without authoriza-
tion
Notify the person responsible immediately of any modification.

Safety during operation on page 79
5.2.1

Control panel B34H

RPM indication
EMERGENCY-STOP push button
Selector switch rotational direction
Left hand motion/ clockwise rotation
Machine illumination ON/OFF
Switch for the turning direction
The direction of rotation of the geared drill can be performed using the rotation direction switch.
It is possible to select two speed stages for each direction of rotation using the switch.

The labeling "R" means right-handed rotation.

The labeling "L" means left-handed rotation.

Speed table B34 H on page 102
ATTENTION!
Wait until the rotation of the drill spindle has come to a complete halt before changing
the rotation direction using the rotation direction switch.
A change over of the rotation direction during operation may result in a destruction of
the motor and of the rotation direction switch.
Push button ON
The push button "ON" switches on the rotation of the drilling spindle.
Push button OFF
The "push button OFF" switches the rotation of the drilling spindle off.
GB B34H | B34HV
96
Abb.5-1: Operating element on the control panel B34H
Translation of the original instructions
Push button "ON"
Push button "OFF"
Version 1.1.3 - 2020-07-21
Operation