Herunterladen Inhalt Inhalt Diese Seite drucken

Battery And Rechargeable Battery Notes; Declaration Of Conformity (Doc) - Reely Power Drone XL Bedienunganleitung

Elektro-quadrocopter
Vorschau ausblenden Andere Handbücher für Power Drone XL:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Battery and Rechargeable Battery Notes

Although use of batteries and rechargeable batteries in everyday life is a
matter of course today, there are many dangers and problems. In particular
in LiPo/LiIon batteries with high energy content (as compared to conventional
NiCd or NiMH batteries), various provisions must be complied with to avoid
danger of explosion and fire.
The model is delivered with a rechargeable battery and a matching charger.
Nevertheless, we are including extensive information on handling batteries
for safety reasons. Should you use your own accessories, please ensure you
follow all information enclosed by the respective manufacturer.
a) Transmitter
• Keep batteries/rechargeable batteries out of the reach of children.
• Do not leave any batteries/rechargeable batteries lying around openly. There is
a risk of batteries being swallowed by children or pets. If swallowed, consult a
doctor immediately!
• Batteries/rechargeable batteries must never be short-circuited, disassembled or
thrown into fire. There is a danger of explosion!
• Leaking or damaged batteries/rechargeable batteries can cause chemical burns
to skin at contact; therefore, use suitable protective gloves.
• Do not recharge normal batteries. There is a risk of fire and explosion!
• Make sure that the polarity is correct when inserting the batteries (pay attention
to plus/+ and minus/-).
• If the device is not used for an extended period of time (e.g. storage), remove the
inserted batteries from the remote control to avoid damage from leaking batteries.
• Always replace the whole set of batteries. Do not mix full batteries with half-full
ones. Always use batteries/rechargeable batteries of the same type and manu-
facturer.
• Never mix batteries and rechargeable batteries!
b) Flight Battery
• After the flight, the LiPo flight battery must be disconnected from the electronics
system of the flight model. Do not leave the LiPo flight battery connected to the
helicopter electronic system when you do not use the flight model (e.g. during
transport or storage). Otherwise the LiPo flight battery may be fully discharged.
This would destroy the rechargeable battery and render it unusable! There is also
a danger of malfunction due to interferences. The rotors could start up inadvertent-
ly and cause damage or injury.
• Never charge the LiPo flight battery immediately after use. Always leave the LiPo
flight battery to cool off first (at least 5 - 10 minutes).
• Due to the special battery plug, the flight battery can be charged with conventional
LiPo chargers only if using matching adapters. Therefore, use the included USB
LiPo charger only to charge the flight battery.
• Only charge intact and undamaged batteries. If the outer isolation of the rechar-
geable battery is damaged or the battery is deformed or bloated, it must not be
charged. In this case, there is immediate danger of fire and explosion!
• Never damage the exterior of a LiPo flight battery. Never cut the covering foil.
Never stab any LiPo flight batteries with pointed objects. There is a risk of fire
and explosion!
• Remove the LiPo flight battery that is to be charged from the model and place it on
a fire-proof support (e.g. a plate). Keep a distance to flammable objects (use USB
extension cable if required).
• As the charger and the rechargeable LiPo flight battery both heat up during the
charging procedure, it is necessary to ensure sufficient ventilation. Never cover
the charger or the LiPo flight battery! Of course this also applies for other chargers
and rechargeable batteries.
• Never leave LiPo batteries unattended while charging them.
• Disconnect the LiPo flight battery from the charger when it is fully charged.
• Chargers may only be operated in dry rooms. The charger and the LiPo flight
battery must not get damp or wet.
• There is the risk of fire or explosion by the rechargeable battery in case of error.
LiPo batteries specifically react very strongly at moisture and oxygen due to the
chemicals contained in them! Do not expose the charger or LiPo flight battery to
high/low temperatures or to direct solar radiation.
Disposal
a) Product
Electronic devices are recyclable and should not be disposed of in household waste.
Dispose of the product according to the applicable statutory provisions at the end of
its service life.
Remove any inserted batteries/rechargeable batteries and dispose of them sepa-
rately from the product.
b) Batteries/Rechargeable Batteries
You as the end user are required by law (Battery Ordinance) to return all used batteries/re-
chargeable batteries. Disposing of them in the household waste is prohibited.
Batteries/rechargeable batteries that contain hazardous substances are labelled
with the adjacent icon to indicate that disposal in domestic waste is forbidden. The
descriptions for the respective heavy metals are: Cd = cadmium, Hg = mercury,
Pb = lead (the names are indicated on the battery/rechargeable battery e.g. below
the rubbish bin symbol shown on the left).
You may return used batteries/rechargeable batteries free of charge at the official collection
points in your community, in our stores, or wherever batteries/rechargeable batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

Declaration of Conformity (DOC)

Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declares that this
product complies with directive 2014/53/EU.
The complete text of the EU declaration of conformity is available under the follow-
ing web address:
www.conrad.com/downloads
Choose a language by clicking a flag symbol and enter the order number of the
product into the search field; then you may download the EU declaration of conform-
ity in the PDF format.
Technical Data
a) Transmitter
Transmission frequency....................................... 2.4 GHz
Transmission output ............................................ 5.6 dBm
Transmitter range ................................................ max. 40 m
Operating voltage ................................................ 6 V/DC (4 batteries type Mignon/AA)
Dimensions .......................................................... 150 x 115 x 84 mm (W x L x H)
Weight (without batteries) .................................... 117 g
b) Quadrocopter
Dimensions .......................................................... 273 x 273 x 86 mm (W x L x H)
Diameter of the rotors .......................................... 122 mm
Weight ................................................................. 57 g
Take-off weight .................................................... approx. 66 g (incl. flight battery)
Permissible flight operation ................................. Halls and outdoors
Operating conditions ............................................ Windstill or light wind
Permitted temperature range ............................... 0 °C to +40 °C
Permitted humidity ............................................... max. 75% rel. humidity, non-condensing
c) Charger
Operating voltage ................................................ 5 V/DC (via USB)
Required input current ......................................... min. 1 A
Charge end voltage ............................................. 4.2 V (LiPo 1S)
Charge duration ................................................... approx. 90 minutes
d) Rechargeable Battery
Type ..................................................................... LiPo, 1 cell
Rated voltage ...................................................... 3.7 V
Capacity ............................................................... 300 mAh
Discharge rate ..................................................... 20 C
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE.
*1550780_V1_0617_02_VTP_m_short_en

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis