Contents Of The Setup-Menus - WIKA CPH6000 Betriebsanleitung

ProcessCalibrator
CPH6000
8.3 Display contents of SETUP-MENUS
GB
a ->
b ->
c ->
d ->
e ->
f ->
g->
h->
i->
j->
a) MEASURING: Operating mode MEASURING
To measure working/process pressures

For comparative measurements and/or calibrations (without data recording)

of mechanical* & electrical pressure measurement instruments (supply &
display of the test item through the CPH6000)
For further information see Chapter 9.1 and 9.2
b) CALIBRATION: Operating mode CALIBRATION
For on-site calibration of mechanical* & electrical pressure measurement

instruments (without PC). In this case the data sets (for up to 16 test
specimens, each with up to 32 test points including Date & Time) are
recorded within the CPH6000.
For further information see Chapter 9.3
The calibration data can be transferred into printable certificates
using either PrintCal or EasyCal software.
c) SWITCH TEST: Operating mode SWITCH TEST
For the easy checking/verification of pressure switches, including automatic

calculation of the switch hysteresis.
For further information see Chapter 9.4
* For mechanical indication instruments, the test item measured value must be entered via the Numeric Keypad.
28
SETUP
WIKA Operating Instructions ProcessCalibrator