WIKA CPH6000 Betriebsanleitung Seite 26

ProcessCalibrator
CPH6000
In MEASURING mode, in addition to the reference-pressure value, a test item can
GB
also be displayed on the screen in parallel (see following picture).
For configuration instructions, please see Chapter 9.1 and 9.2
Display: MEASURING with test item
Measuring range of the test item
Current measured-value of the test item
Deviation/Difference between reference and
test item in the selected pressure Units and,
either, in % of the measuring range (% FS) or
Output signal (type) of the test item
Current value of the output signal (test item)
26
% of measured-value (% rd)
Pressure signal (test item)
Electr. signal (test item)
WIKA Operating Instructions ProcessCalibrator
pressure unit
(of test item)
P
switchable
I/U