General - WIKA CPH6000 Betriebsanleitung

ProcessCalibrator
CPH6000

1. General

GB
In the following chapters detailed information on the ProcessCalibrator CPH6000
and its proper use can be found.
Should you require further information, or should there be problems which are not
dealt within detail in the operating instructions, please contact the address listed
on the last page.
Factory calibration of the instrument is according to relevant international stan-
dards.
The warranty period for the CPH6000 ProcessCalibrator is 24 months according to
the general terms of supply of ZVEI.
The guarantee is void if the appliance is put to improper use or if the operating
instructions are not observed or if an attempt is made to open the appliance.
We also point out that the content of these operating instructions neither forms
part of an earlier or existing agreement, assurance or legal relationship nor is me-
ant to change these. All obligations of WIKA Alexander Wiegand GmbH & Co. KG
result from the respective sales contract and the general business terms of WIKA
Alexander Wiegand GmbH & Co. KG.
WIKA is a registered trade mark of WIKA Alexander Wiegand GmbH & Co. KG.
Names of companies or products mentioned in this handbook are registered trade
marks of the manufacturer.
We reserve the right to effect reasonable changes on the basis of technical impro-
vements.
Any reproduction of this manual or parts thereof by any means is prohibited.
Version key regarding firmware and respective manual.
Manual
V 1.1
V 1.2
© 2005 Copyright WIKA Alexander Wiegand GmbH & Co. KG
4
Firmware
31.08.05
34.10.05
WIKA Operating Instructions ProcessCalibrator