WIKA CPH6000 Betriebsanleitung Seite 33

ProcessCalibrator
CPH6000
9.2 MEASURING mode (with test item)
To switch the instrument into "MEASURING" mode (with test item display the test
signal as an electrical signal or as a pressure), in order to carry out a comparati-
ve measurement / Calibration without measured-value recording, then follow the
instructions on the previous page.
The following is a more detailed explanation of Point: "2. Preparation for
MEASUREMENT"
a: Test item and respective test item signal [0 ... 20 mA / 4 ... 20 mA / 0 ... 1 V /
0 ... 2 V / 0 ... 5 V / 0 ... 10 V / or mechanical for pressure gauges]
If a comparative measurement with a mechanical gauge (test item) is being
made, then the gauge's measured value should be entered via the numeric
keypad and confirmed with ENTER.
b: Lower limit of test item measuring range
c: Upper limit of test item measuring range
d: Measurement accuracy of the test item in % FS (with respect to the span) or
% rd (with respect to the measured value)
e: Measurement accuracy of the test item in %
f: Units & resolution (Sub-menu)
g: Measurement type for the test item (relative or absolute)
h: Test medium (pneumatic -> gas & hydraulic -> oil)
i: Power supply for test item (on/off) [If no external supply is required for the
test item, "OFF" should be selected to conserve energy]
xxx Current coursor position; alter via
} Parameter-selection from list or menu via
0.00 Parameter input using numeric keypad
Input confirmation
ENTER
WIKA Operating Instructions ProcessCalibrator
Choose & select (standard units)
via
SELECT
Customer-specific units; with respect to
bar (Input via numeric keypad)
Display resolution in operating mode via
(back with
BACK
Clear input
CLEAR
)
33
GB