WIKA CPH6000 Betriebsanleitung Seite 6

ProcessCalibrator
CPH6000
8. The display window is made of glass (which can splinter). Unless there is no
GB
possibility of this glass breaking during operation, anyone in the close vicinity of
the equipment, must wear eye protectors, both before and during operation.
9. Test and calibration assemblies must always be constructed and also dis-
mantled in an unpressurised state (atmosphere).
10. If the CPH6000-Pressure Sensor is used for applications with oil as the fluid
media, then subsequent use with fuels or gases is prohibited, since this could
cause an explosion and risks harm to both people and machinery.
11. If the equipment is damaged and might no longer operate safely, then it should
be taken out of use and securely marked in such a way so that isn't used
again.
Operator safety may be at risk if:
There is visible damage to the device

The device is not working as specified

The device has been stored under unsuitable conditions for an extended

period of time.
If there is any doubt, please return the device to the manufacturer for repair or
maintenance.
12. Customers must not attempt to alter or repair the device themselves. Please
return the device to the manufacturer for any repair or maintenance.
13. Any operation not included in the following instructions or outside the
specifications must not be attempted.
6 WIKA Operating Instructions ProcessCalibrator