Re-Calibrating And Servicing; Transport Of The System - WIKA CPH6000 Betriebsanleitung

ProcessCalibrator
CPH6000

12. Re-calibrating and servicing

GB
We recommend having the system re-calibrated by the manufacturer at regular
intervals of approx. 12 months. Every re-calibration at the factory also includes a
comprehensive and free checking of all system parameters.
Maintenance advice

Both the CPH6200 and sensors are manufactured using solid-state technology,
and contain no moving parts which could wear. If the instrument housing has
been opened, the warranty becomes invalid.
To clean the membrane keyboard and the display, use only customary plastic or
glass cleaning agents in compliance with the guidelines of the manufacturer. Use
clothes which are not prone to generate fluffs.
Before cleaning the surface of the instrument, it has to sure that it
is not pressurized, the power switched off and the power supply
disconnected.
The electrical connections along the upper edge of the
instruments should not come into contact with a damp cloth.

13. Transport of the system

Before the system is shipped all remains of any medium stuck to
it must be removed. This is particularly important if the medium is
a health hazard such as a corrosive, toxic, carcinogenic,
radioactive, etc.
Before returning any equipment, please fill out the appropriate Goods-Return
Form, found on the WIKA Web site (www.wika.de see: Service/Product return),
and a reference number will be issued to you. Then send the instrument with this
reference number attached to the delivery address indicated.
Please follow the following instructions to prevent damage.
1. Wrap the system in antistatic plastic foil.
2. Using the insulating material, place the system in the box in such a way that
there is about the same amount of insulating material on all sides of the
transport box.
3. If possible add a bag of desiccant to the box
52 WIKA Operating Instructions ProcessCalibrator