Interface; Clear Caldata - WIKA CPH6000 Betriebsanleitung

ProcessCalibrator
CPH6000
i) Current battery charge level
At 10 % the low battery charge warning "low BAT" is shown in the display.
10.6 SETUP-Additional menu items: Digital Interface
This menu allows the configuration of the digital interface. It can be configured for
USB or RS-232.
Regarding the RS-232 interface there is a choice of 3 different baud rates with 8
fixed data bits used, no parity and 1 stop bit.
10.7 SETUP-Additional menu items: CLEAR CalData
If the menu item "CLEAR CalData" is selected using the cursor and the SELECT-
button is pressed 2 times, all calibration data which is stored in the instrument will
be deleted all at once.
Note: The state of the erasing procedure (some seconds) will be
shown in the lower info line.
WIKA Operating Instructions ProcessCalibrator
Marks the current configuration

Choice of the interface
Confirmation of the choice
SELECT
Alternation between type of inter-
face and baud rate
GB
49