WIKA CPH6000 Betriebsanleitung Seite 31

ProcessCalibrator
CPH6000
9.1 MEASURING mode
In order to switch the instrument into "MEASURING" mode, follow the instructions
on the previous page.
The following is a more detailed explanation of Point: "2. Preparation for
MEASURING"
a: Test item type and respective test item measurement signal: [----] for mea-
surement without test specimen
b: Lower limit of test item measuring range
c: Upper limit of test item measuring range
d: Measurement accuracy of the test item in % FS (with respect to the span) or
% rd (with respect to the measured value)
e: Measurement accuracy of the test item in %
f: Units & resolution (Sub-menu)
g: Measurement type for the test item (relative or absolute)
h: Test medium (pneumatic -> gas & hydraulic -> oil)
i: Power supply for test item (on/off) [If no external supply is required for the
test item, "OFF" should be selected to conserve energy]
xxx Current coursor position; alter via
} Parameter-selection from list or menu via
0.00 Parameter input using numeric keypad
Input confirmation
ENTER
WIKA Operating Instructions ProcessCalibrator
Choose & select (standard units)
via
SELECT
Customer-specific units; with respect to
bar (Input via Numeric Keypad)
Display resolution in operating mode via
(back with )
BACK
Clear input
CLEAR
GB
31