WIKA CPH6000 Betriebsanleitung Seite 29

ProcessCalibrator
CPH6000
d) Functions: Operating functions such as:
Tare: Offset correction for reference pressure sensors

Min/Max: Minimum/Maximum memory

Alarm: Min/Max alarm (visual & audible)

Filter: Smoothing the signal of the reference sensor

For further information see Chapter 10.1
e) CPH-Info: General CPH6000 instrument data such as:
Calibration data for the electrical measurement inputs

Firmware number

Serial-No. of the device

For further information see Chapter 10.2
f) Reference Sensor: Data for the currently connected reference pressure
sensor such as:
Measurement range

Accuracy class

Sensor measurement type

Information in the event of reference sensor overpressure

Calibration data for the reference sensor

For further information see Chapter 10.3
g) Reference Sensor list:
List of the stored reference sensors that can be attached and calibrated.

For further information see Chapter 10.4
h) CPH Settings:
Info: on battery level

Display options of: Menu language, system time / system clock, display-

brightness, powersave function (automatic energy saving mode; see
Chapter 10.5)
Entry/Input options:

- ambient temperature during the calibration (see Chapter 5.2)
- height difference between reference and pressure sensor
(see Chapter 5.2).
For further information see Chapter 10.5
i) Digital Interface:
 Switch between USB and RS-232 digital interfaces incl. baud rate entry
For further information see Chapter 10.6
j) Clear CalData:
 All stored calibration data will be deleted (Clear complete storage space)
For further information see Chapter 10.7
WIKA Operating Instructions ProcessCalibrator
GB
29