WIKA CPH6000 Betriebsanleitung Seite 43

ProcessCalibrator
CPH6000
9.4 PRESSURE-SWITCH TEST mode
In order to switch the instrument into "PRESSURE-SWITCH TEST" mode, follow
the instructions on the previous page.
The SWITCH TEST function is not suitable for electronic switches,
e.g.: PNP- or NPN switches, but is only for mechanical, volt-free switches.
The following is a more detailed explanation of Point: "2. Preparation for
PRESSURE SWITCH TEST"
a: Power supply for test item (on/off) [If no external supply is required for the
test item, "OFF" should be selected to conserve energy]
b: Units & resolution (Sub-menu)
The calculated measured values of the two switching points and the
hysteresis can be reset by pressing the "0" key.
xxx Current coursor position; alter via
} Parameter-selection from list or menu via
0.00 Parameter input using numeric keypad
Input confirmation
ENTER
WIKA Operating Instructions ProcessCalibrator
Choose & select (standard units)
via
SELECT
Customer-specific units; with respect to
bar (Input via numeric keypad)
Display resolution in operating mode via
(back with )
BACK
Clear input
CLEAR
GB
43