Instrument Status Messages Shortly After Switching On The Cph7650; Display Contents Of The Operating Modes - WIKA CPH7650 Betriebsanleitung

6. Commissioning, operation
6.5.2 Switching the pressure calibrator off
The instrument is switched off using the "CPH switch of" menu item in the first
submenu.
For this, press the [SETUP] button, select the "CPH switch of" menu item and confirm
EN
using the [SELECT] button.

6.5.3 Display contents of the operating modes

Operating mode: MEASURING
When a CPH7650, with a CPT6000 reference pressure sensor connected to it, is
first switched on, the instrument (after displaying a brief status message) switches to
MEASURING mode (see following figure)
Display indication
MEASURING with reference pressure sensor only (without test item)
Measuring range of the CPT6000 reference pressure sensor (which is currently connected)
1
Current measured value of the reference pressure sensor
2
Pressure unit (adjustable via menu)
3
34
.Configuration
MEASURING
CALIBRATION
SWITCH-TEST
Functions
CPH-Info
ReferenceSensor
Ref. Sensor-list
CPH-Configuration
Interface
CLEAR CalProg
CPH switch off
Measuring
Reference
1
0.000
0.000
2
Testitem
0.000
0.006
Dev.:
0.006
0.10
Switching off
13:28
10.000
3
bar
6.000
bar
bar
%FS
WIKA operating instructions, model CPH7650