Pushing The Tubular Motor Into The Winding Shaft; Preparatory Work When Using Precision Tubes - RADEMACHER 2540 06 36 Betriebs- Und Montageanleitung

Pushing the tubular motor into the winding shaft ( Figure  )
STOP
1. First, push the driver (8) into the winding shaft (5)
IMPORtANt
When installing winding shafts such that the rabbet is on the inside, it must be
ensured that the motor (9) has sufficient free space.
Preparatory work when using precision tubes (Figures
5.a
Rollotube Comfort Small
5.b
Rollotube Comfort Medium
5.c
Do not push the motor (9) into the
winding shaft (5) using force.
This could destroy the motor.
1 
1 
2. then push the winding shaft (5) onto the adapter (10).
IMPORtANt
Make sure that the adapter (10) does not slide off the limit ring (18) on the motor
head (12) during assembly as this can cause malfunction, see page 56.
-
1. Measure the distance between the adapter and the rear third of the
driver and mark this distance on the precision tube.
2. Saw a notch 1 at the end of the precision tube so that the raised part
 of the adapter can be pushed fully into the tube.
NOtE
◆ There must be no play between the notch 1 and the raised part .
◆ The dimensions of the notch 1 depend on the type of tubular motor, see figures.
EN
)
49