Sliding The Tubular Motor Into The Rotating Union (Figure ); Preparation For Use Of Precision Tubes - RADEMACHER RolloTube I-line Funk Small Bedienungsanleitung

Sliding the tubular motor into the rotating union (Figure
STOP
1. First slide the catch (8) into the rotating union (5).
IMPORTANT
The motor (9) must have sufficient free space for rotating unions with internal felt.
Preparation for use of precision tubes (Figures
IMPORTANT
◆ Please only use precision tubes made from aluminium.
◆ The following steps can be left out when using octagonal steel shafts.
5.a
RolloTube I-line Radio Small (ILFS...)
5.b
RolloTube I-line Radio Medium (ILFM...)
5.c
38 38
Never knock the motor (9) with force
into the rotating union (5).
Doing so will cause serious damage.
ALUMINIUM
2. Subsequently, press the rotating union (5) fully onto the adapter (10).
IMPORTANT
In doing so, ensure that the adapter (10) does not slip off of the limit ring (18) on
the drive head (12) during the assembly process. Otherwise malfunctions may occur,
see page 50.
-
)
1. Measure the distance between the adapter (10) and the rear third of
the catch (8) and mark this distance on the precision tube.
2. Saw a groove in the end of the precision tube
of the adapter (10) can be pressed fully into the tube.
NOTE
◆ There may not be any play between the groove
◆ The dimensions for the groove
see figure.
)
in order that the cam
and the cam
are dependent on the tubular motor type used,
EN EN
.