Electrical Connection; Cable Routing - Balluff BCM R15E-00 DI00 S4 Serie Betriebsanleitung

BCM R15E-00 _ -DI00-_ _ , _-S4
Condition Monitoring Sensor
4
Installation and connection (continued)
4.3

Electrical connection

1
4
3
Fig. 4-8: Pin assignments for connector (pin side view)
Pin Wire color Signal
1 Brown +24V (operating voltage UB+)
3 Blue GND (operating voltage UB-;
reference potential)
4 Black C/Q (IO-Link)
Tab. 4-1: Plug connector pin assignment
4.4

Cable routing

Cable length
Cable length max. 20 m.
Cable routing
NOTICE
Damage to the sensor
Excessive strain on the cable can damage the sensor.
► The cable must be routed tension-free.
► Avoid tensile forces on the cable (observe a
maximum tensile load of 20 N).
Do not route the cable between BCM and IO-Link master
or between IO-Link master and controller/Edge gateway
near high voltage cables (inductive interference can occur).
The cable must be routed such that it is free of tension
(tensile force < 20 N).
Bending radius for fixed cable
The bending radius for a fixed cable must be at least three
times the cable diameter.
Bending radius for flexible routing
The bending radius for flexible cable routing must be at
least five times the cable diameter.
www.balluff.com english 17