Installation And Connection; Installation; Electrical Connection; Shielding And Cable Routing - Balluff BOS R254K-UUI-PR10-S4 Betriebsanleitung

BOS R254K-UUI-PR/R_1_-S4
Photoelectric Sensors
5

Installation and connection

5.1

Installation

For dimensions, see Fig. 4-1 on page 7.
CAUTION
Red light
If you look into the light beam emitted by the transmitter,
temporary blinding and irritation of the eyes is possible.
The use of operating elements or the implementation of
settings or processes which are not described in this
user's guide may cause dangerous radiation exposure.
► Locate transmitter units so that it is not possible to
look into the light beam even during operation.
► Take specifications in this user's guide into
consideration.
The sensor can be fastened with two M4 screws.
Plug outlet direction:
Fig. 5-1: Example image of use with angled connector
8 english
5.2

Electrical connection

1
2 4
3
Fig. 5-2: Plug layout (top view of M12 plug on BOS)
Pin Signal
1 L+ (Operating voltage +, SIO 10...30 V,
IO-Link 18...30 V)
2 ...-PR10/RE10/RS10-...
I/Q (Digital input / digital output / analog output)
...-RH10/RH11-...
I/Q (digital input / digital output)
3 L− (Operating voltage −)
4 C/Q (IO-Link communication / digital output in SIO
mode)
Tab. 5-1: Pin assignment
Factory setting
– Mode: SIO mode
– Object recognition operating mode: Standard
– PIN 2: Switching output (push-pull)
– PIN 4: Switching output (push-pull)
Also see document IO-Link configuration under
www.balluff.com on the product page.
5.3

Shielding and cable routing

Cable length
For IO-Link operation, the maximum cable length is 20 m.